3 Flute, flush trim bits with ball bearing guide. (Replacement bearing sold separately).

With ball bearing guide. Eliminates hand filing of laminates that normally follows trimming. These specially designed tools will flush trim the laminate and "break" the sharp edge all ....

15° bevel, 4 wing, laminate trim cutter assembly. Includes: Cutter, arbor and ball bearing guide.

2 Flute, overhang trim bit with ball bearing guide. Used primarily for laminate trimming, leaving a small overhang. Reduced chipping of material caused by excessive feed-rate or ....

2 Flute beading bit with ball bearing guide.

2 Flute corner beading bits with ball bearing guide. This group is particularly suitable for antique reproductions and restoration projects.

2 Flute, multi-beading bit with ball bearing guide.

10° hook, 15mm pitch, alternate top bevel (ATB) grind. For general cut-off, cross-cutting and trimming of natural woods.

10° hook, 15mm pitch, triple chip (TC) grind. For general trimming and cross-cutting of natural woods, plywood, composition material and single or double-sided plastic laminated ....

10° hook, 15mm pitch, combination grind, 4ATB & 1 raker. Designed for ripping and cross-cutting natural woods. Teeth consist of four ATB, alternate top bevel, followed by one square ....

Single flute keyhole bit with 1/4" shank. Used for cutting keyhole slots in plaques, picture frames and other wall hanging items.

6° negative hook, 10mm pitch, 25° high-ATB grind. Specifically designed to cut melamine chip-free on both sides provided that your table saw fence is square to the blade and arbor is ....

2 flute V-Groove bits.

2 flute with ball bearing guide. (Replacement bearing sold separately).

2 flute with upper ball bearings. Very useful for template and pattern routing where the template is on top of the workpiece. Ball bearing guide rides against the template for an ....